Replacing the Cylinder
IMPORTANT!
Ensure that the new cylinder is free of damage or defects.
Figure 7 - Removing the Cylinder (front panel removed for clarity)
Replacing the Cylinder: Warning/Fault
When the cylinder needs to be replaced, you will receive a notification on the Condair HumiLife
and on the humidifier (
and
). If the cylinder is not replaced within roughly 3 weeks, the
warning notification upgrades to a fault notification and the humidifier stops steam production.
Replacing the Cylinder:
1. Turn off the humidifier and allow the cylinder to drain. Close the water shut-off valve. Allow
the cylinder to cool down. Use the electrical disconnect to remove power from the unit.
2. Open the door to the humidifier.
3. Pull the lever upwards. The lever will push the cylinder out.
4. Pull the cylinder out of the humidifier.
Caution
: some left over water may spill.
l
The plumbing cover may now be removed, if necessary, to gain access to the hoses,
fill cup, fill valve, and drain valve. Refer to
"Removing the Plumbing Cover" on the
5. Return the plumbing cover (if removed), then replace the cylinder with a new one. Put the
new cylinder into the humidifier and secure it with the lever.
6. Shut the door, restore power, and open the water supply. The unit will go through a new
cycle and will automatically detect a new cylinder.
Note:
It takes some time for the unit to verify a new steam cylinder. Allow some time for the
humidifier to regain normal humidification capacity.
If you still receive an warning or error for the new cylinder; reset the error (press and hold the power
button for 3 seconds). If the problem still persists, you may have a defective steam cylinder.
Condair RH
2594949_B_EN_2005_Condair-RH_OM
Maintenance | 17
Summary of Contents for HumiLife RH Series
Page 31: ...Page intentionally left blank...
