aCKNOWLEDGEmENT
Thank you for purchasing a Concept product. We hope you wilbe satisfied with our product throughout its
service life.
Please study the entire Operating Manuacarefully before you start using the product. Keep the manuain
a safe place for future reference. Make sure other people using the product are familiar with these
instructions.
Technical parameters
Voltage
220–240 V ~ 50/60 Hz
Power input
2200 W
Stainless steel ironing surface
*
Anti-drip
*
Anti-calc
*
Anti-drip = Function preventing water from dripping at low temperatures
Anti-calc = Function avoiding limescale deposits
ImPORTaNT SaFETy PRECaUTIONS
•
Make sure the mains voltage corresponds to the values on the rating plate.
•
The iron is designed for
domestic
use in accordance with intended purpose.
•
Never put the iron in water
or other liquids to avoid electric shock hazard and resulting injuries.
•
The filling hole shall not be open during operation.
•
Make sure the iron is disconnected from the mains before you start filling the water tank.
•
Use distilled or boiled water only for filling the tank. Do not pour any other liquid to the tank than water.
Do not put any admixtures into the water. The internal parts of the product can be damaged.
•
Always set the iron at the minimum level when connecting and disconnecting from the wall outlet.
•
Use and store the iron on a stable surface.
•
When disconnecting the power cord from the wall outlet, never pull the cable. Grasp the plug and
disconnect it by pulling.
•
The power cord must not come into contact with hot surfaces.
•
High temperatures
occur during operation, which may cause burning.
•
Always use the handle. Notify others (especially children) of the possible risk of scalding by steam, hot
water or the working surface of the iron, particularly when ironing in the vertical position.
•
Disconnect the iron from the wall outlet after use.
•
Check the power cord for possible damage regularly.
•
If the power cord is damaged, it must be replaced by a competent person. This is necessary to avoid
possible injury.
•
Do not let the power cord hang over the edge of a table within reach of children.
•
Store the iron in the vertical position standing on the rear surface of the iron. Let the iron
cool down
properly
before storing. Do not touch hot surfaces.
•
Keep the product out of the reach of children.
•
When putting the iron on a stand, make sure that surface supporting the stand is stable.
•
Do not continue using the iron if it has dropped, it shows any traces of damage, or it is not tight.
Failure to follow the manufacturer‘s instructions may cause refusal of warranty repair.
EN
33
ZN8012
