38
39
EN
EN
VP6120
VP6120
OPERATING INSTRUCTIONS
Vacuum cleaner assembly
Always disconnect the plug out of the electrical outlet before assembling or removing accessories!
1. Attach the extension tube (5) into the hand unit of the vacuum (4) until you hear a click sound. To remove the tube
from the hand unit, press the release button (7) and pull away. By pulling the plastic part of the pipe (5), the pipe can
be bent in the joint. When straightening the pipe, you will hear a crack, the pipe will be fixed in a straight position
in the elbow.
2. Attach the turbo nozzle (6) to the extension tube (5), you will hear a click sound. To remove the turbo brush from
the extension tube, press the lock button (7) and pull away.
You can insert the turbo nozzle to the hand unit as described (4).
BATTERY INSTALLATION
Insert the battery (2) into the body of the hand unit (4) and push it lightly. When you hear a click, the battery has been
successfully installed. To release the battery, press the battery release button (3) and pull to remove it.
The battery charging point is located on the bottom of the handle of the hand unit.
Note:
To prolong the battery life, always charge the battery when the battery is nearly empty. Do not store or recharge
the appliance in environment with temperatures below 0 °C or higher than 40 °C. These temperatures may damage the
appliance. During the charging process, the temperature of the appliance may increase, this is normal.
While the battery is being charged, the power indicator (D) flashes and remains lit after charging. If both indicators (E, D)
are lit during operation of the vacuum cleaner, the battery is sufficiently charged. If only one indicator is on or flashing,
the battery needs to be charged.
If you do not use the vacuum cleaner for more than 3 months, allow it to charge for 12 hours. Then place the vacuum
cleaner in a dry and cool place.
OPERATION
Before installing the battery, check if it is fully charged.
1. Press the power button (A) located on the handle of the rod part of the vacuum cleaner to switch on the appliance.
2. By pressing the button (B) repeatedly, you can change the power of the vacuum cleaner (3 power levels are
available).
3. After switching the vacuum cleaner on, the 2nd power level is automatically set.
4. The current power level is indicated by a light signal (C).
5. At the lowest power, i.e. level 1, signalling (C) is not on. When medium power is switched on, i.e. level 2, the
signalling lights up white, at maximum power, i.e. level 3, the signalling lights up blue.
Note:
We recommend to use the maximum power of both the hand unit and the turbo brush in the case of heavily soiled
surfaces or medium-high or high pile carpets.
ACCESSORIES
Select the accessories according to the nature of the surface to be cleaned.
Mini turbo brush
– suitable for bed linen, fabric, sofa, etc.
Slot nozzle
– suitable for wall corners, car cushioning, radiators, etc.
Nozzle with a brush
– suitable for bedding, fabric, sofa, etc.
Hardfloor brush
– suitable for hard floors
Wall stand
– assembly kit
EMPTYING AND CLEANING THE DUST CONTAINER
1. To empty the dust container (8), first press the dust container release lock (16) and remove the container from the
hand unit (4).
2. Press the dust container lock (9) to open the container, empty the dust, remove the soiled filters from the container
and clean them.
3. Insert cleaned filter back in the dust container and close the lid.
4. Insert the dust container (8) back in the hand unit, you must hear a click.
REMOVING AND CLEANING THE FILTER
Turn the lid of the hand unit to the left and, after releasing, pull out the HEPA filter vertically. The HEPA filter can be rinsed
in water. Allow the HEPA filter to dry before returning it back to the hand unit.
