Concept2 KS3006, Manual

Page: 37 / 60

EN
28 KS3006
Assembly:
1. Draw two parallel lines 335 mm apart on the wall according to Fig. 3.
2. Mark and drill two holes corresponding with the diameter of the supplied dowels on the top line. The distance
between their centres is 400 mm.
3. Mark two holes with their centres 396 mm apart on the bottom line so that they are symmetrical with the top
holes. Drill the bottom holes with a drill of appropriate diameter according to the supplied dowels.
4. Insert the supplied dowels in the four holes.
5. Put the supplied screws in the top holes. Allow an approximate 8 mm clearance between the screw head and the wall
(Fig. 4).
6. Put suspension hooks on the screw heads and firmly tighten the screws (Fig. 5).
Dowel
Screw
Screw
Suspension hook
7. Screw the spacers to the bottom section of the appliance (Fig. 6). Make sure the spacers are located on the same
side as the cut-outs for suspending the appliance.
Fig. 3
Fig. 6
Fig. 4 Fig. 5
400 mm
396 mm
335 mm
EN
29 KS3006
8. Hang the appliance on the suspension hooks installed on the wall and screw the spacers into the bottom holes
(Fig. 7).
9. Make sure the appliance is firmly installed on the wall and there is no danger of its fall during operation.
CAUTION
When turning the appliance on for the first time or after a prolonged downtime, it may produce a slight smell. This
smell will vanish after a short time.
OPERATING INSTRUCTIONS
1. If you use the appliance as a free-standing unit, place it on a stable surface or floor to prevent it from overturning.
If the appliance is mounted on a wall, make sure that all flammable substances in its vicinity conform to the
minimum distance requirements.
2. Uncoil the supply cable completely.
3. Connect the power cord plug to the mains socket outlet.
4. Use the mode selector (4) to choose the power output 750, 1250 or 2000 W.
5. Use the thermostat regulator (3) to adjust the required room temperature. When 750, 1250 or 2000 W power
outputs are selected, the unit will alternately switch on and off, thus keeping the required temperature. You can
activate a fan with a switch (5) to rapidly reach the required room temperature.
Note: You can set a more accurate temperature in the following way:
Set the thermostat to a maximum value, then switch the unit to the heating mode (750, 1250 or 2000 W). When
the required room temperature is reached, turn the thermostat (3) slowly to a lower temperature until the unit
switches off.
6. After use, switch off the unit and unplug it from the mains outlet.
CLEANING AND MAINTENANCE
Warning!
Always disconnect the power supply cable from the mains outlet before cleaning the appliance.
Fig. 7
EN
37 KS 3006