91
EN
IDV4430
Sealing
Fig. 9
Hob
Retaining clip
Worktop
Fig. 10
Removal
To uninstall the unit, it is important to proceed correctly:
1. First, switch off the circuit breaker and unplug the mains cable from the socket.
2. Remove the retaining clips.
3. Take out the hob and at the same time pull out the mains cable carefully.
Connecting to the mains power
•
Only a qualified person can install this appliance!
•
Make sure that the parameters on the rating plate are compatible with the electrical ratings of the main power
supply.
•
Make sure that the parameters on the rating plate are compatible with the mains voltage and
the current
protection.
Otherwise the installed electric circuit could be overloaded, especially in the case of single-phase
connection (230 V).
•
If the hob is connected to the mains power in a single phase (see Connection of the terminal box of the appliance), all
cooking zones cannot be used for maximum performance. The hob automatically reduces the power consumption
of individual cooking zones to avoid overloading of the circuit breaker.
•
We recommend using a self-contained electrical circuit to connect to the mains.
•
Use solely electric power distribution with PE protective conductor.
•
Do not use multi-plug adapters, connectors and extension cables. Risk of fire due to overheating!
•
Make sure that there is access to the mains plug or the circuit breaker after the installation.
•
The electrical safety of the appliance can only be guaranteed if the protective terminal of the unit is connected to
the protective conductor of the mains.
•
The manufacturer is not responsible for any injuries or damages that are the result of incorrect or missing protective
installation.
•
Make sure the mains cable or plug does not touch the hot appliance or hot cookware, to prevent it from becoming
deformed and excessively bent.
•
In the event of disconnecting the hob from the mains power, all set parameters will be reset and the hob control
panel will be locked.
9. Position the appliance onto the edge of the worktop and pass the mains cable through the opening so that the
plug or terminals remain accessible after installation.
10. Push the appliance carefully into place. Make sure not to cause damage to the mains plug or to the mains cable.
11. The bottom of the hob base is fitted with a sealant to prevent it from moisture and leakage of liquids. After
installation the space between the edge of the hob and the worktops should be min. 3 mm (Fig. 9).
12. Secure the hob in the required position from the bottom to the worktop with the supplied retaining clips (Fig. 10).
13. Connect the supply cable to the terminal box and then turn on the appropriate circuit breaker on.
Summary of Contents for IDV4430
Page 2: ......
Page 21: ......
Page 96: ...CZ SK PL Seznam servisn ch m st Zoznam servisn ch stredisiek Wykaz punkt w servisovych...
