52
EN
IDV2460
WARNING!
• The touch control is activated by placing a finger on the required symbol on the glass-ceramic plate. Therefore, keep
the control panel clean and dry.
• The sensors do not respond to matte, dark colours (do not use black gloves). Do not place anything on the control
panel of the heating plate.
• Make sure the unit is prevented from being accidentally switched on, e.g. by a pet.
• When the heating plate is disconnected from the mains, the set parameters are reset and the heating plate control is
locked.
• In monophase connection (see Connection of the terminal box) all the hotzones cannot be used at maximum power.
To prevent power overload of the respective circuit breaker, the unit automatically reduces the input of individual
hotzones.
Before the first use
Prior to putting a new unit into operation, wipe it with a wet cloth.
Switch-on of the heating plate
To switch on the heating plate, press the ON/OFF symbol (1). If you do not make a further selection within 2 minutes, the
heating plate automatically switches off.
Switching on a hotzone
1. Press the symbol for hotzone selection (8) to activate the hotzone. „0“ symbol is blinking for the selected hotzone on
the display (3).
2. Set the required power level by repeatedly pressing the „+“ or „-“ symbol (2) to choose from
1
up to
9
. If you do not set
the power level within 10 seconds, the heating plate will return to hotzone selection mode.
Note:
If the „
U
“ symbol is shining on the display (3), the cooking utensil’s bottom diameter is too small or it is made of
an unsuitable material. Use a smaller hotzone or utensil with a larger bottom diameter or a utensil made of another
material.
Switching off a hotzone
1. Press the symbol for hotzone selection (8) to activate the hotzone (number of the selected hotzone is blinking).
2. Set the power level to „
0
“ gradually by repeatedly pressing the „-“ symbol, or switch the hotzone off by simultaneously
pressing both the symbols „+“ and „-“.
3. After the hotzone has been switched off, its display may show the „
H
“ symbol indicating that the zone is hot and there
is a risk of burning. This residual heat can be utilised.
Powerbooster function
This function enables the heating of food even faster than at the highest power setting of the heating plate. The
powerbooster function will increase the power of the highest heating level for a short time at the front left hotzone.
To activate this function:
1. Press the symbol for hotzone selection (8) to activate the front left hotzone.
2. Press the symbol to switch on the Powerbooster function. The letter „
P
“ will be displayed.
3. The Powerbooster function will be automatically deactivated after 5 minutes, unless deactivated earlier manually.
To deactivate this function:
1. Press the symbol for hotzone selection (8) to activate the front left hotzone.
2. Press the or „-“ symbol to switch on the Powerbooster function. The letter „P“ from the display disappears. Thus the
Powerboost function is deactivated.
Note:
The Powerbooster function will reduce the power level of other hotzones to prevent power overload of the
heating plate.
