EN
42
ETV3160
f) Cooling fan
The fan is located on the upper side of the oven and provides the circulation of cool air in the furniture. The
fan switches on automatically when the oven is switched on. When the oven is switched off, the cooling fan is
deactivated after about 15 minutes.
CLEANING AND MAINTENANCE
For the sake of good appearance and reliability, keep the unit clean.
The modern design of the unit facilitates the maintenance to the minimum.
The parts of the unit which come into contact with food have to be cleaned regularly.
• Before any maintenance and cleaning, disconnect the power cord from the mains or switch off the circuit breaker of
the mains outlet of the unit.
• Set all controls in the OFF position.
• Wait until the inside of the unit is not hot anymore but remains lukewarm – cleaning is easier than when it is cold.
• Clean the outer surface of the unit with a damp cloth, soft brush or fine sponge and then wipe it dry.
• The inside of the oven can be wiped with a damp cloth, soft brush or sponge. In the case of heavy dirt, use hot water
with a non-aggressive detergent.
• To clean the glass of the oven door do not use coarse abrasive cleaners or sharp metal scrapers, since they can scratch
the surface or the glass can be broken.
• Never leave aggressive or acidic substances (lemon juice, vinegar) on the enamelled, varnished or stainless parts.
• Do not use an autoclave to clean the unit!
• The baking pans may be washed in a dishwasher.
UNIT INSTALLATION
• Only the customer is responsible for installation in situ. Defects caused by incorrect installation are not covered
by the warranty.
• The manufacturer bears no responsibility for damage caused to people, animals or objects as a result of incorrect
installation.
• To ensure the correct function of the unit, place it in suitable furniture.
• The unit should be installed in standardised kitchen furniture designed for built-in appliances or in properly
adapted furniture of dimensions according to Fig. 8a, 8b.
• The kitchen furniture must be made of sufficiently heat-resistant material. The materials and adhesives used
must be resistant to heating of the unit according to standard ČSN EN 60335-2-6. Materials and adhesives that
do not meet the stated standard may deform or loosen.
Connecting to the mains
• Make sure the mains voltage and current protection correspond to the values on the rating plate. We recommend
using a separate outlet circuit with a 16A circuit breaker.
• Use grounded wall outlets only.
• Do not use adapter plugs, connectors or extension cables. They could create a risk of fire due to overheating.
• The supply cable plug has to be freely accessible even after the installation of the unit.
• Only a qualified expert can perform connection changes.
