Concept Smoke Screen SENTINEL S30, Installation And Operation Manual

Page: 8 / 16

Page 8 of 16
CIRCUIT BOARD LAYOUT
PCB Connection Terminals
Mains fuse (10 Amp)
Tamper Jumper
Programming Dip Switches 1 & 2
Activation test button
“PB1”
Programming button “PB2”
Indication LED
GENERIC CONNECTION DIAGRAM
20130828-S30 Generic Connection Diagram-v2
●
Tamper
●
Tamper
●
0v (100mA)
●
12v (100mA)
●
Hold Off
●
Hold Off
●
Verification NO
●
Verification NC
●
Verification COM
●
UPS Status NO
●
UPS Status NC
●
UPS Status COM
●
Fluid Status NO
●
Fluid Status NC
●
Fluid Status COM
●
Not Ready NC
●
Not Ready NO
●
Not Ready COM
●
Trigger
●
Trigger
●
Alarm Set
●
Alarm Set
S30 Generic Connection Diagram
PIR or other S30 Notes
final confirm ation device
Tamper Tamper
Tamper Tamper
0v 0v DC
12v 12v DC
Alarm Panel or sim ilar control device Alarm
Hold Off
Alarm Hold Off
Input 1
+ve
Verification n/o
Machine activating Verification n/c
Ground
Verification com
Input 2
+ve
UPS n/o
UPS failure UPS n/c
Ground
UPS com
Input 3 +ve Low n/o
Fluid low Low n/c
Ground
Low com
Input 4 Ready n/c
Machine ready +ve Ready n/o
to activate
Ground
Ready com
Set Trigger
Set
Trigger
Intruder
Alarm
Intruder Alarm
"Tamper" changes state if the S30 case or external tamper
is open. n/c and n/o show n are w hen the case is closed.
Outputs
"Ready" changes state if there is a critical fault. n/c and n/o
show n are w hen the S30 is w orking correctly.
"Low " changes state if the S30 fluid is low . n/c and n/o
show n are w hen there is fluid available.
"UPS" changes state if there is a UPS fault. n/c and n/o
show n are w hen the UPS is w orking correctly.
Alarm Panel detects n/o
circuit going closed to
signal the specified event.
Alarm Panel ouput contacts
should be clean relay
closed pairs energising
open on set / intruder.
"Verification" changes state w hen the S30 fires. n/c and
n/o show n are w hen the S30 is not firing.
"Alarm Set", "Trigger" and "Hold Off" should be connected
to normally closed clean contacts going open to fire the
S30. All 3 must be open to fire the S30.
DC output for additional device. Total S30 output must not
be greater than 100mA.
See note for "Alarm Set" and "Trigger". Leave open if no
device fitted.