Concept Smoke Screen SENTINEL S30, Installation And Operation Manual

Page: 6 / 16

Page 6 of 16
ACCESS
To access the PCB connections and programming buttons (fluid bag
access covered in the relevant section) remove the front cover by
unscrewing the 2 set screws on either side and the 2 countersunk set
screws in the top; refitting is the reverse process. Installation cable
entry is through the grommet on the top, right back of the case.
MOUNTING
The Smoke Screen can either be ceiling mounted, or wall mounted, using the bracket supplied. If
ceiling mounted, it is recommended that the Smoke Screen is suspended on 2 lengths of M8 studding
from a Unistrut section (pictured). In all cases, the installer must fit the Smoke Screen using appropriate
fasteners.
Suspension Kit (All M8)
Uni-strut 1 x 1 metre
Threaded bar 2 x 1 metre
Fixings:
2 x 38mm washer
4 x 25mm washer
6 x full nut
2 x drop-in anchor
2 x channel nuts,
Wall mounting
The Smoke Screen can be wall mounted to fire horizontally, or angled to fire down at 15, 30 or 45
degrees, using a simple wall bracket (1) that should be attached to a suitable wall using
appropriate fixings. We recommend as high a position as possible for aesthetic and security/anti-
tamper reasons, but no higher than 3 metres above the floor. Select the most appropriate one of
the 2 pairs of threaded holes on each side of the Smoke Screen and insert a set screw a few
threads into the bottom hole on each side (2). Carefully locate the Smoke Screen on to the bracket
by sliding the bottom set screws in to the wall bracket hooks and then insert one set screw on each
side to lock the unit at the required angle (3). Tighten all four set screws.
NOTE
If the Smoke Screen
has been in service
the heater block will
be extremely hot and
will cause injury if
touched.
1 2 3