Conair TrueFeed, User Manual, Page: 15 / 47

APPENDIX B SHOWS THE PRINT VIEW WHICH WILL BE EXPLAINED BELOW
1. PROCESSOR BOARD
The processor board is the heart of the controller.
This board must be fixed securely on the main board.
There’s also a label on it with the Mac-address. This is the ID of the network card.
This address can also be seen on the startup screen.
2. EXTERNAL TERMINAL CONNECTION
This connector will be used when using an external terminal (Shielded cable max. 10 m)
3. CONNECTION TO PC OR NETWORK
An Ethernet connection will be used when using a PC or network.
Maximum length of the UTP network cable, type RJ45 (Cat. 5) is 100 meter between 2
network points.
4. INPUTS
Start input
The Dual TrueFeed needs an input signal from the production machine in order to operate.
Three different input signals can be used to control the Dual TrueFeed:
Potential free start input. (dry contact)
Potential (24 Vdc) start input
Tachometer (0-30 Vdc) start input
5. MOTOR
The Dual TrueFeed can control 2 motor types:
LT (low torque) standard motor for normal feeding
HT (high torque) motor for high output feeding
(See Section 5 for more details and wiring diagram for electrical connections, Appendix B)
6. OUTPUTS
The Dual TrueFeed has the following outputs available:
[clamp 24-25] Valve output for hopper loader, (Solid state 24VDC/0.5 A)
[clamp 22-23] Warning output (Solid state 24VDC/0.5 A)
[clamp 26-27] Potential free relay (normally open) output for Alarm (max. 230Vac/30Vdc, 5A)
[clamp 28-29] Potential free relay (normally open) output for Running contact
(max. 230Vac/30Vdc, 5A). This contact will be used to show that the motor is running.
The maximum total output power may be 12 Watt (Valve output and alarm output together max. 0.5A)
(See wiring diagram Appendix B for electrical connections)
7. POWER SUPPLY
The Dual TrueFeed will operate with a voltage from 80 VAC to 260 VAC, 50 and 60 Hz
by integrated automatic voltage selector.
(See wiring diagram Appendix B for electrical connections)
11 Dual Feed TrueFeed Manual