![background image](http://html1.mh-extra.com/html/conair/microkool-mpa/microkool-mpa_user-manual_2649042055.webp)
Press the up
▲
▲
key to begin calibrating.
The controller displays the name of the current calibration
(examples: 32 SC.L; 32 rC.L; 510 SC.H; or 510 rC.H).
Wait until the control displays “don” or “bad.”
A “don” message in the Setpoint display indicates the cali-
bration was successful. A “bad” message in the Setpoint
display indicates a bad calibration.
Press Select to start the next calibration.
Pressing and releasing the Select key at the end of a
calibration tells the controller to perform the next calibra-
tion.
Exit Calibration Mode.
Press and hold the Select key for 3 seconds to exit the
Calibration Mode.
You can now proceed to the next test in Test Mode, or
disable Test Mode and resume normal operation.
C
ALIBRATING
T
EMPERATURE
S
ENSORS
UGH004/0999
microKool Portable Chillers
M
AINTENANCE
5-13
6
7
NOTE: The original calibration value stored in
EEProm can be restored for the current calibration
by pressing the STOP key at any time.
8
TO DISABLE TEST MODE, complete steps 2
through 5 in
P
ERFORMING
S
YSTEM
T
ESTS
, setting dip
switch 6 to OFF instead of ON.
9
Summary of Contents for microKool MPA
