![background image](http://html1.mh-extra.com/html/conair/cts-5/cts-5_user-manual_2649613007.webp)
WARNING: Improper installation,
operation, or servicing may result in
equipment damage or personal
injury.
This equipment should only be installed,
adjusted, and serviced by qualified technical
personnel who are familiar with the construc-
tion, operation, and potential hazards of this
type of machine.
All wiring, disconnects, and fuses should be
installed by qualified electrical technicians in
accordance with electrical codes in your
region. Always maintain a safe ground. Do not
operate the equipment at power levels other
than what is specified on the machine serial
plate.
I
NTRODUCTION
1-3
We design equipment with the user’s safety in mind. You can
avoid the potential hazards identified on this machine by fol-
lowing the procedures outlined below and elsewhere in the
User Guide.
ATTENTION:
R
EAD THIS SO NO
ONE GETS HURT
UGE058/0803
CTS Saw
DANGER: Sharp blades!
Most injuries caused by knife blades occur
when the saw has been turned off. Handle
blades with care at all times.
●
Always wear cut-resistant gloves when the
blade guard is open and when handling
blades.
●
Always lock out the saw before opening any
guards.
●
Always wait until the saw blade has stopped
completely before opening the saw guard.
(approximately five minutes)
CTS Saw are equipped with several safety
devices to ensure safe operation. Never remove
or disable these devices to sustain production.
Operating without these devices can cause
severe injury.
●
The STOP button activates a circuit that
stops the saw.