![background image](http://html1.mh-extra.com/html/conair/cts-5/cts-5_user-manual_2649613041.webp)
UGE058/0803
CTS Saw
M
AINTENANCE
5-3
WARNING: Voltage Hazard
This equipment is powered by alternating cur-
rent, as specified on the machine serial tag and
data plate. Do not operate the equipment at
power levels other than what is specified on the
machine serial tag and data plate.
A properly-sized conductive ground wire from
the incoming power supply must be connected
to the chassis ground terminal inside the electri-
cal enclosure. Improper grounding can result in
severe personal injury and erratic machine
operation.
Before performing maintenance or repairs on
this product, disconnect and lock out electrical
power sources to prevent injury from unexpect-
ed energization or start-up. A lockable device
has been provided to isolate this product from
potentially hazardous electricity.
DANGER: Sharp blades!
Most injuries caused by saw blades occur when
the saw has been turned off. Handle blades
with care at all times.
●
Always wear cut-resistant gloves when the
blade guard is open and when handling
blades.
●
Always lock out power to the saw before
opening any guards.
●
Always wait until the saw blade has com-
pletely stopped before opening the saw
guards. (approximately five minutes.)
CTS saws are equipped with several safety
devices to ensure safe operation. Never remove
or disable these devices to sustain production.
Operating without these devices can cause
severe injury.
W
ARNINGS AND
C
AUTIONS
CONTINUED