3
Ensure the channel nuts are
installed the appropriate posi-
tion on the rack bar.
Insert the M8 cap screws and
spring washers through the
handle and screw onto the
channel nuts.
Using a 6mm allen tool, tighten
the M8 cap screws, locking the
handle in position.
Step 1: Install channel nuts.
Install the channel nuts into the
rack bar. Push the nut (spring
side down), into the channel
and twist to lock into place.
This is done the same side as
gate step will be installed.
Pick a location that can be
comfortably reached from the
ground in a standing position.
Step 2: Install the grab handle.
Step 3: Assemble mounts
.
Slide the step mount hinges
(3) into the step housing (2) as
shown.
2
3
5-6Nm