Comtrol IO-Link Master Initial Installation and Configuration
3. Apply the power and verify that the following LEDs are lit indicating that you are ready to attach
your IO-Link or digital I/O devices.
•
PWR
– a green lit LED indicates the DR-8-EIP is receiving power.
•
MS
, first the flashing green and red LEDs displays that it is in self-test mode. After the self-
test, depending on whether you set the IP address with the rotary switch one of the following
occurs:
o
The green LED is flashing to indicate that the DR-8-EIP is in standby mode.
o
The green LED is lit to indicate that the DR-8-EIP is operational.
•
NS
, first it flashes green and red indicating that it is in self-test mode. After the self-test,
depending on whether you set the IP address with the rotary switch one of the following
occurs:
o
Off indicates there is no IP address
o
Steady red indicates a duplicate IP address on the network
•
LINK
should be lit (green) to indicate a valid network connection.
•
ACT
blinks if there is network traffic between the DR-8-EIP and the network.
•
Port LEDs should display in this manner if there is no device
attached:
o
The IO-Link port LED should be flashing green indicating that it
is searching for an IO-Link device.
o
DI (Digital input) should be off to indicate that there is no device
attached to the port.
If the LEDs indicate that you are ready to attach devices, go the
Using PortVision DX to Program the
IP Address
subsection.
If the LEDs do not meet the above conditions, you can refer to the
3/27/2015
P a g e
|
4