108
Field
Description
802.11n/EWC
An equipment interoperability standard setting based on
IEEE 802.11n Draft 2.0 and Enhanced Wireless Consortium
(EWC)
Bandwidth
Select 20MHz or 40MHz bandwidth. 40MHz bandwidth uses
two adjacent 20MHz bands for increased data throughput.
Control Sideband
Select Upper or Lower sideband when in 40MHz mode.
802.11n Rate
Set the physical transmission rate (PHY).
802.11n Protection
Turn Off for maximized throughput.
Turn On for greater security.
Support 802.11n
Client Only
Turn Off to allow 802.11b/g clients access to the router.
Turn On to prohibit 802.11b/g client’s access to the router.
RIFS Advertisement
One of several draft-n features designed to improve
efficiency. Provides a shorter delay between OFDM
transmissions than in 802.11g.
OBSS Co-Existence
Co-existence between 20 MHZ AND 40 MHZ overlapping
Basic Service Set (OBSS) in WLAN.
RX Chain Power Save Enabling this feature turns off one of the Receive chains,
going from 2x2 to 2x1 to save power.
RX Chain Power Save
Quiet Time
The number of seconds the traffic must be below the PPS
value below before the Rx Chain Power Save feature
activates itself.
RX Chain Power Save
PPS
The maximum number of packets per seconds that can be
processed by the WLAN interface for a duration of Quiet
Time, described above, before the Rx Chain Power Save
feature activates itself.
54g Rate
Drop-down menu that specifies the following fixed rates:
Auto: Default. Uses the 11 Mbps data rate when possible
but drops to lower rates when necessary. 1 Mbps, 2Mbps,
5.5Mbps, or 11Mbps fixed rates. The appropriate setting
is dependent on signal strength.
Multicast Rate
Setting for multicast packet transmit rate (1-54 Mbps)
Basic Rate
Setting for basic transmission rate.
Fragmentation
Threshold
A threshold, specified in bytes, that determines whether
packets will be fragmented and at what size. On an
802.11 WLAN, packets that exceed the fragmentation
threshold are fragmented, i.e., split into, smaller units
suitable for the circuit size. Packets smaller than the
specified fragmentation threshold value are not
fragmented. Enter a value between 256 and 2346. If you
experience a high packet error rate, try to slightly increase
your Fragmentation Threshold. The value should remain
at its default setting of 2346. Setting the Fragmentation
Threshold too low may result in poor performance.
Summary of Contents for VR-3033
Page 1: ...261099 037 VR 3033 Multi DSL Wireless Router User Manual Version A1 0 March 1 2016...
Page 57: ...56 5 3 3 UPnP Select the checkbox provided and click Apply Save to enable UPnP protocol...
Page 64: ...63 A maximum of 100 entries can be added to the URL Filter list...
Page 106: ...105 Enter the MAC address in the box provided and click Apply Save...
