the engine block or to the chassis. If this is not the case, you should consult your dealer.
WARNING:
Lorries generally have two batteries to supply a voltage of 24 volts, in which
case it will be necessary to insert a 24/12 volt converter into the electrical circuit. The
following connection steps should be carried out with the power cable disconnected from
the set.
a)
Check whether the battery is of 12 volts.
b)
Locate the positive and negative terminals of the battery (
+
is red and
–
is black).
Should it be necessary to lengthen the power cable, please use the same or a superior
type of cable.
c)
It is necessary to connect your CB to a permanent (
+
) and (
-
). We advise you to
connect the power cable directly to the battery (as the connection of the CB cable to the
wiring of the car-radio or other parts of the electrical circuit may, in some cases, increase
the possibilities of interference).
d)
Connect the red wire (
+
) to the positive terminal of the battery and the black (
-
) wire to
the negative terminal of the battery.
e)
Connect the power cable to your CB radio.
WARNING:
Never replace the original fuse (10A) by one of a different value.
4
）
BASIC OPERATIONS TO BE CARRIED OUT BEFORE USING YOUR SET FOR THE
FIRST TIME(without transmitting or using the <<Push-To-Talk>> switch on the
microphone)
a) Connect the microphone
