Comtech EF Data SLM-5650B, Installation And Operation Manual

Page: 276 / 412

SLM-5650B Satellite Modem
Revision 2
TRANSEC Module HTTPS Interface 10–20 MN-SLM-5650B
Step Task
5 Confirm that the files have been extracted to the specified temporary folder on the PC.
Using Command-line, type “cd c:\temp” to change to the temporary directory created in Step 2, then use the
“dir” command to list the files extracted from the downloaded archive file.
6 Connect the PC to the modem’s Ethernet via a hub or a switch, or directly to the PC with a crossover cable.
7 Send a “ping” command to the TRANSEC Module to verify the connection and communication.
First, determine the IP address of the TRANSEC Module from the front panel:
SELECT: Configure

Transec

Module IP Address menus.
Then, using Command-line to “ping” the modem – at the prompt, type “ping xxx.xxx.xxx.xxx” (where
‘xxx.xxx.xxx.xxx’ is the TRANSEC Module’s IP address). The results should confirm whether or not the
module is connected and communicating.
8 Initiate a secure Web session with the TRANSEC Module via its HTTPS Interface. Refer to Section 10.3.
Open the TRANSEC Module HTTPS Interface.