Comtech EF Data DMD1050TS, Installation And Operation Manual

Page: 203 / 316

DMD1050TS Satellite Modem Board
Revision 1
TRANSEC Module HTTPS Interface 8–7 MN-DMD1050TS
8.4.1.3 Encryption Parameters
Item Description
Operating Mode Set encryption in the TRANSEC Module as Primary or Secondary.
Note the following:
•
If Primary is selected, the TRANSEC Module will allow the user to advance the
TEK and activate the future key independently of any other modems.
• If Secondary is selected, the TRANSEC Module's TEK automatically mirrors the
TEK of the primary modem and the module will activate the future key when the
primary modem activates its future key.
Click Update Mode when done.
Encryption Click Change Encryption State to display the On and Off radio buttons. The “layered”
appearance of this control is intended to prevent the user from accidentally toggling the
Encryption State.
By selecting the Encryption State as ‘On’, this causes the data traffic to be encrypted by
the TRANSEC Module using the current TEK. This encrypted data is then delivered to the
base modem for transmission, regardless of the state of the receiving modem.
Three user-defined parameters must match in order for encrypted communication to
commence between two TRANSEC Module-equipped modems:
1. Seed Key.
2. Passphrase.
3. Encryption Frame Length.
Select the desired operational state, then click Update Encryption to save the selected
state and then return this selection to its “protected” mode; the On/Off radio buttons will
be hidden once again and the operational state message will update accordingly (i.e.,
“Encryption is On” or “Encryption is Off”).
Encryption Frame
Length
Use this text box to specify the length of the Advanced Encryption Standard (AES) 256
encryption frame. Acceptable range is from 1 (fast acquisition, high overhead) to 255
(slower acquisition, low overhead).
Once the desired Encryption Frame Length has been entered, click Update Frame
Length to implement this change.
Reset all keys Click Zeroize to reset all encryption keys in the module’s memory and flash to default
values.