FP-30 User’s Manual
Chapter 8 Interfacing with the hardware board (On-board connection) 87
8.4
Using a test clip in On-Board connection
For On-board programming, it is recommended to use the adapter cable
[ADP-FP30SA-CBL-S10]
and to use the ISP connector
on the target board.
In case of hardware boards that have already been designed/manufactured without an ISP connector, a test clip can be used to
program the flash memory. This procedure is described in this section.
It is recommended to use the supplied adapter cable [ADP-FP30SA-CBL-S10]
with the ISP connector whenever possible. The method described here is not
guaranteed to work always. Incorrect wiring may cause damage to the board or to
the flash memory and the FP-30 unit.
Follow this method at your own risk.
FP30 unit conversion adapter
[
J1 connector
]
signal table
No.
Signal
name
FP-30
Internal circuit
No.
Signal
name
FP-30
Internal circuit
1
Vtref
4KΩ Pull
-Down
2
*2
(VCCOUT)
Power supply
3
SCLK
22
Ω series
4
GND
GND
5
GND
GND
6
GND
GND
7
CS1
22
Ω series
8
GND
GND
9
SI/SIO0
22
Ω
series
10
GND
GND
11
SO/SIO1
22
Ω series
12
GND
GND
13
SIO2
*1
47
Ω series
14
GND
GND
15
SIO3
*1
22
Ω se
ries
16
GND
GND
17
NC
NC
18
CS2
*1
22
Ω series
19
SRST
100
Ω
series
Open collector output
20
NC
NC
*1
: NC if the pins are not used on the flash memory.
*2
: VCCOUT (the power output from FP-30) is output regardless of C-Flash settings.
Refer section “8.5 Supplying power to target from FP-30”.
In case of SOP 16pin 300mil and SOP 8pin 200mil package flash memory, use a commercially available SOP IC test clip and
connect the flash memory and the conversion adapter [J1 connector] of FP-30.
NOTE
FP30 conversion adapter
J1 connector
FP-30 unit
The (
▼
) mark on the connector is not a pointer
that points to Pin 1.
Flash memory to
be programmed
