FP-30 User’s Manual
Chapter 8 Interfacing with the hardware board (On-board connection) 89
8.5
Supplying power to target from FP-30
Power can be supplied from FP-30 to the hardware board using the adapter cable
[ADP-FP30SA-CBL-S10]
Rev 0-A
and
[C-Flash for SPI] Ver. 1.05.00 or later
. Flash memory on hardware boards with a light load can be written to without having to
supply external power.
Depending on various factors, some boards might still need an external power
supply. Refer to the board manual for details.
Incorrect connection may damage the target board and the FP-30 unit. Follow this
method at your own risk.
8.5.1
Check the re
vision of the adapter cable
Make sure the adapter revision is Rev 0-A before proceeding. The revision can be checked as explained in section
”.
8.5.2
Electrical characteristics
Voltage
1.8V / 2.1V / 2.2V / 2.5V / 2.6V / 2.9V / 3.0V / 3.3V
Current
200mA max
・
The option
[Supply power to the target from FP-30]
has to be checked on the “On-board settings tab” of the
・
Ensure that power is supplied to the hardware board only through FP-30 and no other power supply sources are used.
・
The current consumption of the hardware board must be less than the max current supported by the FP-30 unit.
NOTE
Back side
