Computer Automation Technology CAT-250, Manual, Page: 28 / 55

5-5
Program User Macro Locations (01-40)
Key-up and send [*14XX] followed by a [1] to enable the macro or a [0] to disable the macro. This
feature permits the macro to be turned off without having to erasing it. Un-key and voice will say:
“CONTROL OK.”
Erase User Macro Locations (01-40)
Key-up and send [*15XX]. Un-key, the voice will say: "CONTROL OK."
Event Macro Command Memory
Event Macros are used to perform custom operations at pre determined times during repeater
operation.
MACRO DEFINITION MACRO DEFINITION
01 PORT #1 COR/CTCSS ACTIVE 26 PORT #2 RECEIVE ONLY
02 PORT #1 COR/CTCSS INACTIVE 27 PORT #2 CONNECT
03 PORT #2 COR/CTCSS ACTIVE 28 PORT #2 DISCONNECT
04 PORT #2 COR/CTCSS INACTIVE 29 PORT #2 AUTO DISCONNECT
05 LOGIC INPUT #1 ACTIVE HIGH 30 SCHEDULED EVENT MACRO #30
06 LOGIC INPUT #1 ACTIVE LOW 31 SCHEDULED EVENT MACRO #31
07 LOGIC INPUT #2 ACTIVE HIGH 32 SCHEDULED EVENT MACRO #32
08 LOGIC INPUT #2 ACTIVE LOW 33 SCHEDULED EVENT MACRO #33
09 LOGIC INPUT #3 ACTIVE HIGH 34 SCHEDULED EVENT MACRO #34
10 LOGIC INPUT #3 ACTIVE LOW 35 SCHEDULED EVENT MACRO #35
11 LOGIC INPUT #4 ACTIVE HIGH 36 SCHEDULED EVENT MACRO #36
12 LOGIC INPUT #4 ACTIVE LOW 37 SCHEDULED EVENT MACRO #37
13 PLAY COURTESY TONE #1 38 SCHEDULED EVENT MACRO #38
14 PLAY COURTESY TONE #2 39 SCHEDULED EVENT MACRO #39
15 40 SCHEDULED EVENT MACRO #40
16 SQUELCH TAIL MESSAGE 41 SCHEDULED EVENT MACRO #41
17 TRANSMITTER DROP MESSAGE 42 SCHEDULED EVENT MACRO #42
18 ID MESSAGE INITIAL 43 SCHEDULED EVENT MACRO #43
19 ID MESSAGE PENDING 44 SCHEDULED EVENT MACRO #44
20 ID MESSAGE FORCED 45 SCHEDULED EVENT MACRO #45
21 ID MESSAGE FINIAL 46 SCHEDULED EVENT MACRO #46
22 TIMED MESSAGE #1 47 SCHEDULED EVENT MACRO #47
23 TIMED MESSAGE #2 48 SCHEDULED EVENT MACRO #48
24 DTMF ACCESS UP 49 SCHEDULED EVENT MACRO #49
25 DTMF ACCESS DOWN 50 POWER UP