69
Adjusting the Top of Form from the Operator Panel
Adjusting the
Top of Form
from the Operator Panel affects the current Macro setting if you
decide to permanently save your setting.
Proceed as follows:
1. Press the
Set-Up
button.
2. Press the
Top of Form
button. The printer loads the paper in the current paper path. The
display shows the current Top of Form value.
3. Press the
↑
or
↓
button to move the paper position respectively up or down in steps of
1/60 inch. The new
Top of Form
value appears on the display.
4. When the desired setting is reached:
–
to temporarily save the
Top of Form
Value, press the
Exit
button
–
to permanently save the
Top of Form
Value, press the
Sel/Save
button
.
The paper moves back to its previous position.
To reset the
Top of Form
Value:
•
If you want to quickly reset the
Top of Form
Value to 0/60 inch, press the
Top of Form
button during the procedure described above.
The paper moves to the corresponding
Top of Form
Value, then returns to its previous
position.
Summary of Contents for 9060-LA
