Component Playgrounds PH52, Manual

Page: 10 / 33

3.a. Position parts as shown below and insert assembly into ladders. Use the mark previously made on the top
rail to show you how far the assembly needs to be inserted. Insert set screws into the ladder top sleeve and
tighten until barely snug. Do not secure them at this point.
3.b. Using two strong adults lift the ladders and the A Frame end and allow the ladders to fall into the holes. You
can allow the structure to stand it will not be level at this time.
Situate the ladder and “A” frame legs as desired in the space
. Be certain that the top rail has not slid away
from its correct position. If it has moved, hold onto the ladder and adjust its position on the top rail by pulling
or pushing as necessary. When you are content with the position of the top rail within the top sleeve, secure the
set screws in the top sleeve.
Notice. Ladder rungs are
facing down.
Slide through top sleeve
8’ ladder with sleeves
8’ ladder without sleeves
27’ Toprail