MRF-350i B
ASE
S
TATION
Page 2
Features and Benefits
Interference Rejection and Extended RF Range via RFX-250i
The MRF-350i receives RF (radio frequency) signals via the RFX-250i RF Sensor.
The RFX-250i displays RF interference via a bright red LED, which flickers when
interference is present. Simply relocate the RFX-250i out of the interference.
Expand Range by Adding RFX-250i RF Sensors in Remote Areas
The MRF-350i can power up to three RFX-250i RF Sensors connected in parallel
to the RF Input connector.
Variable IR Output Matches Rear Panel IR Inputs
The MRF-350i is equipped with adjustable IR line outputs, each output can be
individually matched to rear panel IR inputs on any component that is designed
to be operated by a standard IR repeater. The outputs utilize a 3.5mm jack.
Up To Fifteen Equipment Locations With Identical Components
Each MSC System remote is “addressable.” They can be programmed to specifically
control components in a particular room by installing a base station at each
location. In operation it’s simple: when you select a device located in the Den,
the MX series remote only sends commands to the Den. When you select a
device located in the Family Room, the MX-3000i only sends commands to it.
A Single MRF-350i Can Control an Array of Identical Components
or Identical Zones of a Multi Zone Preamp/Matrix Switcher
Each MRF-350i has six “addressable” IR Line Outputs. For example, you can control
up to six identical TV’s with one MRF-350i or route volume commands for a
specific zone to a particular zone IR input on a multi-zone preamp. If you have
more than six identical components or zones, up to 15 additional MRF-350is can
be installed to control them (thus allowing up to 90 identical components or
zones in one house).
IR Input for Keypads or IR Repeater Systems
The MRF-350i rear panel IR input will relay IR Data from IR repeaters or
Multi-Zone Keypads to all IR line outputs (does not support IR routing). The 5V,
100 milliamp output will directly power some brands and models of keypad
directly.
Parts Guide
The MRF-350i RF Base Station includes:
1 - RFX-250i RF Sensor with integrated
antenna
1 - Mounting plate for RFX-250i
1 - MRF-350i Base Station
1 - Mounting Plate for wall mounting the
MRF-350i
8 - Screws for wall mounting the two
mounting plates
1 - 9V-300mA Power Supply
6 - Visible Flashers with 10 foot plug in cables.
6 - Extra self adhesive pads for Emitters
1 - 12’Connecting Cable
1 - Adjustment Tool (Screwdriver for RF ID
and IR level adjustment)
2 - Depluggable screw connectors for RF
connections when extending wires.
