4
EnhanceAir™PRO Kit
Instructions
EnhanceAir™ PRO 2 Kit Assembly
EnhanceAir™ PRO 2 Kit:
Step 1:
Thread the Brass Tubing Connector
(D) onto the Air Pump. Lightly tighten with a
wrench. Do Not over-tighten.
Step 2:
Slip one end of the short piece of
Vinyl Tubing (E) over the Brass Connector.
Step 3:
Slip the other end of the Vinyl Tubing
(E) over the bottom end of the Manifold As-
sembly (F) (see image on page 3).
Step 4:
Un-roll both Self-weighted Airlines
and push one end of each onto the open ends
of the Manifold Assembly (F).
Step 5:
Push the other ends of the Self-
weighted Airline onto the barbed connector on
the Air Diffusers (B).
Step 6:
Place the Pump at the edge of the
pond and the Diffuser Assemblies into the
pond at desired locations. See page 4 for
placement guidelines.
EnhanceAir™ PRO Aeration Kit Installation
To install the EnhanceAir™ PRO Aeration Kit into your pond or water garden, first find
a suitable place
outside
of the pond for the air pump. Such a place should be level, flat
and
above
the water level in the pond to avoid water siphoning back into the pump in a
power failure. Next find a suitable place
in
the water garden for the diffuser. For warm
weather operation, this will be near the center of the pond. For winter operation or using
the aeration kit as a de-icer, read the section labeled “
Winter Operation Consider-
ations
.” Do not place the diffuser at depths greater than 4 feet as this will greatly reduce
air flow and reduce the life expectancy of the air pump. After the diffuser and air pump
are in place, take actions to conceal the self-weighted tubing, like snaking it through
rocks or burying it under mulch. Do not place the tubing anywhere it can be stepped on,
run over or otherwise damaged. Do not kink or pinch tubing.
Notes on Installation
·
Pump must be above water level in the pond and on a horizontal surface.
·
Elevate air pump a few inches off the ground to keep moisture from coming in contact
w/ the pump.
·
Do not allow pump to be exposed to the elements. It is highly recommended to use a
vented
cover, such as an artificial rock or irrigation valve box, to protect the pump.
·
If using multiple diffusers (EnhanceAir™ PRO 2), ensure diffusers are evenly distrib-
uted throughout the pond. Also, make sure air flow to each diffuser is regulated by a
valve. Adjust these valves to balance the air flow to each diffuser. Ensure that valves
balance
air flow between diffusers and avoid restricting overall air flow from the pump.
·
The pump will automatically operate when plugged in. Pump must be plugged into an
oulet with a proper ground. If your outlet has no ground, contact an electrician to prop-
erly ground the unit. Also, pump must be plugged into an outlet protected by a Ground
Fault Circuit Interupter (GFCI or GFI).
Step 1
Step 3
Step 4
Step 5- See page 3
Step 2
