WPJ558 Hardware Manual
9
Patches from Compex (support ath9k): sdkowrt-130603.tar.bz2
For first build:
$ cd
$ tar jxf sdkowrt-130603.tar.bz2
$ cd sdkowrt-130603
$ make
The compiled firmware is in:
sdkowrt-130603/openwrt/bin/ar71xx/openwrt-ar71xx-generic-wpj35-squashfs-factory.img
For subsequent build:
$ cd
$ cd sdkowrt-130603/openwrt
$ make
Compiling OpenWRT on ath10k for 11ac radios, with patches from Compex.
-
Recommended Linux host: CentOS 6.x, Debian 6.x
-
During the first build of openwrt, about 300MB of various source files
-
will be downloaded from the internet.The downloaded files will be put in openwrt/dl.
-
Patches from Compex (support ath10k): sdkath10k-130716.tar.bz2
For first build:
$ cd
$ tar jxf sdkath10k-130716.tar.bz2
$ cd sdkath10k-130716
$ make
The compiled firmware is in:
sdkath10k-130716/openwrt/bin/ar71xx/openwrt-ar71xx-generic-wpj344-squashfs-factory.img
For subsequent build:
$ cd
$ cd sdkath10k-130716/openwrt
$ make
OpenWRT Firmware will be in bin/openwrt-ar71xx-wpJ558.bin
Upgrade Firmware with Serial Console
Power on the device, press Esc button from Keyboard. It would be directed to the u-boot loader mode.
-
Open the tftp server (Tftpd32.exe) and select the location of firmware folder.
-
To flash the firmware type the following the command
-
#cpximg <copy the file’s name>
-
Wait to complete the firmware loading. Reboot the device after update successfully.
Upgrade Firmware using TFTP [uboot loader version is b130802 onwards
-
Press and hold the reset button while power up the board.
-
Release the button after 1 second
-
Wait for the Diagnostic led to blink fast.
-
Open the command prompt and type the following command.
-
#tftp –i 192.168.1.1 put <firmware.img>
-
Diagnostic led is always on while writing flash.
-
Diagnostic led blinks slowly after flash firmware.
-
Power off and power on again to reboot the device.
Default Configurations
LAN (bridge eth0+ath0):
IP Address: 192.168.1.1
Wireless (ath0):
Summary of Contents for WPJ558 HW
Page 1: ...WPJ558 HW Manual ...
