WPJ558 Hardware Manual
8
6. Let it run until u see “go”
7. Open command prompt
8. tftp upbios.tst
9. tftp uboot.bin (please observe the DIAG LED is off)
10. If either step 9 or step 10 fail, please start from step 3 again.
11. Power off the device and unplug JTAG cable
12. Power on the device and tftp the firmware into the device.
13. Reboot when done.
BUILD AND INSTALL PROCESS
For OpenWRT firmware on uboot Loader
Minimun Requirement
1
．
OpenWRT will only be supported on WPJ558 with 8MB NOR flash and above.
2
．
Please ensure that the Ethernet connection is able to ping address = 192.168.1.1
Compiling OpenWRT on ath9k with patches from Compex.
-
Recommended Linux host: CentOS 6.x, Debian 6.x
-
During the first build of openwrt, about 300MB of various source files
-
will be downloaded from the internet.The downloaded files will be put in openwrt/dl.
Summary of Contents for WPJ558 HW
Page 1: ...WPJ558 HW Manual ...
