Compass Model SPORT X, Assembly Manual

Page: 3 / 32

• Fly only at approved flying fields and obey field regulations.
• Follow frequency control procedures. Interference can be dangerous to all.
• Obtain assistance from experienced pilots.
• The Guidance provided by experienced pilots is valuable and sometimes necessary.
• Know your radio. Check all transmitter functions before each flight.
• Be aware that rotating blades are very dangerous and can cause serious injury.
• Never fly near or above spectators or other modelers.
• Do not fly r/c helicopter models near buildings, high voltage cables, trees or other obstacles.
• If a beginner, get help trimming the model first and flight training later.
• Don’t “track” the main blades by holding the tail boom. This is a temptation to builders who cannot hover yet and is very dangerous.
• Follow all recommended maintenance procedures for model, radio and motor.
• Only turn off the radio after the engine is shut down.
Necessary items
Bearing Retainer
At least a 6 channel radio and receiver
4 standard servos.
1 gyro with rudder servo.
5V receiver battery
or 2 cell li-po battery with a regulator.
Grease
Needle Nose Pliers Screw Driver
Hex Wrench
(1.5mm,2mm,2.5mm,3mm)
Cutter Knife
Main Rotor Blades
Pitch Gauge Ball Link Sizing Tool
Ball Plier
In order to operate this model, you need to purchase the following items not kit-included.
Swash Plate tool
Guidelines for Safe R/C Helicopter Flight
Thread Lock
Battery
Gyro
Servos
Engine Starter Glow Igniter
Starter Shaft Fuel Filter
Class 50 Engine
Muffler for 50 Class
Glow Fuel for
Model Engines
Fuel Pump
Length: 600~ 620mm