0
10
20
30
40
3
Boom & Tail Rotor
Pos
Description
Qty
1
M3x75 Socket Head Bolt
4
2
3mm Washer
11
3
M3 Nylon Nut
8
4
M3X16 Socket Head Bolt
2
5
M3X25 Socket Head Bolt
3
6
M3X10 Socket Head Bolt
1
7
Boom Support Collar
2
3
4
3
2
Be careful not to over tighten the
bolts when attaching the tail rotor
blades. The tail blades should be
able to move with a slight amount
of resistance within the tail blade
holders.
To pull the belt through the tail boom, slide a cord through
the boom and fix the belt very carefully at the cord. You can
also use a strand and bend a hook at one of the ends.
Crimping the belt damages the
tensile cords and will result in
premature failure!
Slide the tail case completely onto the boom, align it to
the Compass writing and fix it with the clamp on the rear
side. The two locking bolts must be screwed completely
into the case to pierce the boom. After this step, the
angle of the writing can not be adjusted any more!
6
Tip
:
Do not tighten the bolt of the belt
tensioner pulley yet, it will be adjusted
later.
Use medium Threadlock on all
screws going into metal parts
Tip
:
You can use a very small drop of thin
CA glue to secure the pin in the tail pulley.
