0
10
20
30
40
1
Servo
The Servo installation is done without
the supplied Servo Rubbers.
Swashplate Servo
Installation
1
9
1
1
2
3
4
5
Pos
Description
Qty
1
M2.5x10 Socket Head Bolt
12
2
M2x8 Socket Head Bolt
4
3
Stainless Ball
4
4
M2 Nut
4
5
Servo Bolt
4
6
Servo Spacer
2
7
M2.5x20 Socket Head Bolt
4
8
Servo Nut
2
9
2.5mm Washer
12
For mounting the swashplate servos to the bearing blocks, tighten all bolts of the upper bearing block
with medium threadlock. Fix the servos at the upper bearing block. Install the main shaft through all
bearing blocks and push the middle bearing block up against the bottom of the cyclic servos. Tighten the
four screws in the X-shaped parts that secure the middle bearing block. Now slide the main shaft up and
down to make sure the bearing blocks are all aligned. If the main shaft doesn't slide freely, loosen the
screws of the bearing blocks and tight them in a cross pattern. The bearing blocks must be aligned
parallel to each other. You can control this by comparing the height of the bearing block in the long holes
of the side frame. Do not forget to apply new threadlock when loosened a screw!
Use these long holes to adjust
the middle bearing block to fit
different servos.
Remove the black cap of the canopy standoff to loosen
and tighten the screw for adjusting the bearing block.
Use medium threadlock on all
screws going into metal parts
