Installation
Installing the Router in a Rack
The following items in the router kit are used to rack-mount the router:
•
•
•
•
Mounting rails
Extender brackets
Bag of mounting hardware (8 #10-32x.6 Phillips screws, 8 #6-32x.312 Phillips
screws)
Compaq bezel blank
NOTE:
The installation process requires a #2 Phillips and a #2 flat-head screwdriver.
To install the router in the rack:
1.
Remove the router from its protective bag.
CAUTION:
Place the router onto a smooth surface away from any potential
exposure to direct sunlight, liquids or vapors, excessive heat, or risk of accidental
dropping or other damage.
2.
Determine where the router will be mounted, making sure that the airflow vents
remain clear of obstructions.
3.
Separate the inner rail from the outer rail assemblies.
See Figure 2-1 for an illustration.
a.
Place a thumb or finger over the circular grasping hole at the front-end of the
inner rail.
b.
Extend the inner rail out from the outer rail assembly until it locks into place.
c.
Press the spring latch on the back-side of the inner rail to release the lock.
While holding down the spring latch, extend the inner rail until the two rails
separate.
Network Storage Router N1200 Installation Guide
2-3
COMPAQ CONFIDENTIAL
Writer: Mark Garza File Name: c-ch2 Installation.doc
Codename: Myst-Riven Part Number: 283394-002 Last Saved On: 4/26/02 2:59 PM
