2–4
FCA2257C cPCI Host Bus Adapter for Sun Solaris Installation Guide
Installing the Adapters
4. Place the adapter into the slot. Carefully press the adapter into the slot until the
adapter seats firmly (the switch clicks into a locked position when the adapter is
seated). The indicator lights change as follows:
•
The bottom indicator light next to (or above) the slot changes from amber to
off.
•
The top indicator light changes to green.
•
The hot swap LED on the adapter turns blue while the adapter is inserted.
5. Perform one of the following:
•
If the LED turns off, the adapter is inserted and has been configured; continue
with step 7.
•
If the LED stays blue after the adapter is inserted, continue with step 8.
6. Enter the
cfgadm
command to verify that the system recognizes the adapter and
that the adapter is not configured.
In the following example, the shaded row indicates that the adapter has been
installed in slot 4. “Disconnected” in the Receptacle column indicates the adapter
is not configured.
7. Enter the
cfgadm -c configure
slot path
command to configure the adapter.
In the following example, the adapter is configured for slot 4:
cfgadm -c configure pcisch2:sg6slot4
Ap_Id
Type
Receptacle
Occupant
Condition
N0.IB6
CPCI_I/O_bo
connected
configured
ok
N0.IB8
unknown
empty
unconfigured
unknown
N0.SB0
CPU_Board
connected
configured
ok
N0.SB2
CPU_Board
connected
configured
ok
c0
scsi-bus
connected
configured
unknown
pcisch0:sg6slot2
stpcipci/fhs connected
configured
ok
pcisch0:sg6slot3
unknown
empty
unconfigured
unknown
pcisc1:sg6slot0
unknown
empty
unconfigured
unknown
pcisch2:sg6slot4
unknown
disconnected
unconfigured
unknown
pcisch2:sg6slot5
unknown
connected
unconfigured
unknown
pcisch3:sg6slot1
unknown
empty
unconfigured
unknown