Configuring the GbE Interconnect Switch Using the Web-Based Management Interface
Compaq ProLiant BL p-Class GbE Interconnect Switch User Guide
4-11
COMPAQ CONFIDENTIAL
Codename: Vanilla Part Number: 263680-001 Last Saved On: 4/23/02 10:02 AM
3. Configure
the
Speed/Duplex
setting for the port:
NOTE:
If you have the ProLiant BL p-Class F-GbE Interconnect Kit option with the DualTSX
Interconnect Modules, the management interface supports only 1000M/Full and Auto options for
the
Speed/Duplex
fields for the Gigabit uplink ports. The fiber DualTSX Interconnect Module
supports
only 1000-Mb/s (Gigabit) speed,
and
not
10-Mb/s or 100-Mb/s.
— Select
Auto
to allow the port to select the best transmission speed, duplex mode, and
flow control settings based on the capabilities of the device at the other end. The
other selections allow you to force the port to operate in the specified manner.
— Select
1000M/FULL
for port operation at 1000 Mb/s and full duplex.
— Select
100M/FULL
for port operation at 100 Mb/s and full duplex.
— Select
100M/HALF
for port operation at 100 Mb/s and half duplex.
— Select
10M/FULL
for port operation at 10 Mb/s and full duplex.
— Select
10M/HALF
for port operation at 10 Mb/s and half duplex.
4. Configure
the
Flow Control
setting for the port:
— Select
On
for flow control.
— Select
Off
for no flow control.
IMPORTANT:
You must reboot the GbE Interconnect Switch before a flow control change can take
effect.
5. Click
Apply.
NOTE:
To save the configuration settings permanently, you must enter them into NVRAM using
the
Save Changes
option on the
Maintenance
menu. Refer to the section, “Saving Changes,”
earlier in this chapter.
