W
HITE
P
APER
(cont.)
Document No. 308402-001
2
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
Battery Reserve
– Also called Memory Retention Time. The battery reserve acts as a
backup battery for the Pocket PC. It also determines the length of time that the unit will
retain user data and programs in RAM after the main charge is depleted. While in
Battery Reserve mode,the power button cannot be used to turn on the unit. This period
starts after the final warning of low power and ends when the battery disconnects via
software to prevent over-discharge. It is important to connect the Pocket PC to AC
power and recharge the battery before the battery disconnects to prevent loss of user
data and programs.
Full Reset
– Also called Hard Reset or Cold Boot. This is accomplished by placing the
battery into Battery Disconnect mode,then re-activating the battery. Disconnect the
battery by pressing and holding application buttons
1
and
4
simultaneously while
pressing the reset switch for approximately 5 seconds. A full reset will clear both running
programs and erase user data and programs in RAM. Information such as contacts and
appointments are stored permanently in non-volatile memory or Permanent PIM. A full
reset will return the Pocket PC to the factory default settings but will not erase the
contents of the File Store or a backup of contacts or appointments from Permanent PIM.
Learn Cycle
– Also called Battery Calibration. This is a routine that can start when the
battery has completely discharged to the point of disconnecting the battery. As the
battery is charged,parameters that are used to monitor or report battery status are
reset. The Learn Cycle routine cannot be started in any other manner.
Normal Reset
– Also called Soft Reset or Warm Boot. This is accomplished by pressing
the reset switch located on the bottom of the unit for 2 seconds with the stylus. A
normal reset will clear any running programs,but will not erase user data and programs
in RAM.
RAM
– Also called Memory. Random-access memory (RAM) is a type of memory that is
written to and erased many times. The user data in RAM can be lost if battery or AC
power is no longer available. RAM in the unit is used for two purposes – storing user
data and programs,and running programs. The allocation of memory for each purpose
is managed automatically. This can be viewed by tapping
→
Start
→
Settings
→
System
→
Memory
.