Removal and Replacement Procedures
2-9
To replace a DIMM on the system board:
IMPORTANT:
A DIMM can be installed only one way. Be sure to match the key slots on the module with
the tabs on the memory slot. Push the module down into the slot until it is fully inserted and properly
seated.
1.
Identify the correct DIMM socket to populate. See Figure 2-2 earlier in this section.
2.
Open the DIMM socket latches if they are not already opened.
3.
Align the key slot in the bottom edge of the DIMM with the tab in the expansion socket.
CAUTION:
The system does not recognize improperly aligned or seated DIMMs.
4.
Insert the DIMM at the same angle as the DIMM socket on the system board
. As the
DIMM enters the socket, the latches close
.
2
2
1
2
Figure 2-4. Replacing a DIMM in a DIMM socket
CAUTION:
Use only Compaq DIMMs. DIMMs from other sources can adversely affect data
integrity.
5.
Press down firmly on the DIMM while pushing the latches inward until the latches snap
into place.
Summary of Contents for 222863-001 - TaskSmart W2200 Model 10
Page 6: ......
