![background image](http://html1.mh-extra.com/html/companion/comp7012/comp7012_instruction-manual_2644725005.webp)
5
1. ASSEMBLY
Review the contents of the package.
Make sure all listed components are included.
1. Install the burner and reflector plate into the steel
frame, using the wing nut.
2. Align the male end fitting on the Gas Control Assembly
to the venturi tube on the burner and screw in the
internal thread on the burner. Use an adjustable
spanner to tighten until tight.
Take care
not to overtighten as this will strip the
thread in the burner tube.
Note:
Once connected, the gas control does not need to be
removed for storage or when packed away.
2. CONNECTION
Your cooker is designed to connect directly to
a gas cylinder with a POL connector using the
specially designed LP Gas hose and regulator.
1. Check that the cylinder
gas control is in the
“OFF” position (turned
fully clockwise)
2. Take the hose and
attach to the gas inlet
on the appliance, tighten
up using a spanner.
DO NOT
use fingers to
tighten connection.
3. Attach the other end
of the hose with the
regulator to the gas
cylinder, tightening using
the two finger support
posts.
4. Check that gas control
on cooker is turned
“OFF”, then turn the
cylinder gas valve on
in an anti-clockwise
direction for one full
turn and then check the
connections for leaks
with soapy water.
If a leak is detected
turn the cylinder gas valve “OFF” and retighten all
connections then retest.