COMPAL Electronics, INC.
EDM No. S070000031110
.
USER MANUAL
Rev. AB
Page 10
2021/03/
24
Trace design
The trace from module transmitter to antenna connector on the EVB must be maintained identical as the above
specification with i-pex connector. Only trace designs approved by the module original grantee or through permissive
change can be used by an host manufacturer. Any changes are deemed as antenna type change and should be
reviewed to ensure compliance with the FCC regulation rules.
Verification must be conducted and the results shall not exceed below ranges to ensure identical antenna design is
applied to subsequent integration and end product production.
Test procedures of Verification
1.
Set Transmission in the supported modulation mode, band and Channel.
2.
Verify RF tuned-up power through conducted measurement with appropriate cable loss. The KDB guidance
971168 D01 can be followed to obtain the measurement results.
3.
Verify the RF output power results obtained if it’s accordance with the datasheet and test reports.
