Pre-installation Checks
Compac Industries Ltd.
Page 8
www.compac.co.nz
Pre-installation Checks
Transit Damage
Once the unit is received on site, inspect the unit for the following:
Shipping damage to housing, display or any other equipment.
Water damage to components
Report any damage to the transport company and to the help desk.
Take photographs if required.
Tampering
Inspect for:
Evidence of tampering with the unit especially card reader or unauthorised
wiring.
Report any concerns to the help desk.
Take photographs if required.
Vibration
Inspect terminals, plugs and IC chips to check they are securely in place and have
not loosened due to vibration.
Site Issues
Check that all wiring and pipework has been installed correctly and is undamaged.
Report issues to site manager.
Inappropriate installation may void the warranty. If uncertain, contact
your Compac agent for advice.
Site Preparation
Refer to the Site Audit document if supplied.
To ensure maximum operating life, care should be taken when installing the
ComTank components. Considerations should include:
The card reader and PIN pad should face away from the prevailing wind
especially in dusty or wet areas.
In areas experiencing extremes of weather (heat, cold, wind, rain, salt spray
etc.) consideration should be given to installing additional shelter.
The rear of the displays and the electrical components must be protected from
dust, water or high humidity. Any protective surrounds that are constructed must
also allow for adequate cooling.
Inappropriate installation may void the warranty. If uncertain, contact
your Compac agent for advice.