R.5-MAX, R2-MAX
Page 7
Installation and Operation Manual
INSTALL THE R2-MAX
WARNING:
Loudspeakers are heavy. To prevent
injury or damage, they should be supported during
the mounting process until the connection is secure.
q
The R2-MAX loudspeaker is shipped with the yoke
attached. If it is necessary to position the yoke differently,
please remove the mounting hardware and reserve the
hardware for repositioning. Attach the R2 loudspeaker to the
yoke. See
Figure 4a.
Determine and orient the loudspeaker
correctly for the coverage desired for your application.
Mount the loudspeaker to the yoke with the rubber washers
between the yoke and enclosure and attach as shown. This
is intentionally a tight fit to maintain weather resistance.
Tighten bolts to finger tight (enough to hold the loudspeaker
in position).
Figure 3.
Attach the angle securing strap to the R.5-MAX
3/8"-16 x 1-1/4" SS Stud
(leave 3/4" sticking out)
Yoke
3/8" SS Hex Nut
3/8" SS Lock Washer
3/8" SS Flat Washer
Angle Securing Strap
(determine approximate
hole to use based on
chart at right)
Hardware to secure the strap to the yoke
appropriate for yoke attachment to the
structure must be supplied by the installer
Hole #
1
2
3
4
5
6
7
8
9
10 11
Down Angle 3° 6° 14° 18° 20° 25° 29.5° 36° 41.5° 47° 50°
11
10
9
8
7
6
5
4
3
2
1
X°
0°
Securing Strap
R.5-MAX
2" OD Rubber Gasket
1/2" x 1-1/4"
SS Hex Bolt
1/2" SS Lock Washer
1/2" SS Flat Washer
Contour Strap
The short flat end of the contour
strap goes to the rear and the long
flat end should be attached to one
of the side mounting points.
Figure 4b.
Attach the contour strap
Figure 4a.
Mount the R2-MAX loudspeaker to the yoke
2" OD
Rubber Gasket
1/2"-13 SS
Hex Bolt
1/2" SS
Lock Washer
1/2" SS Flat Washer
q
Attach the short flat end of the contour strap to the
mounting point located at the back/center of the enclosure
bell using the bolt, rubber washer, flat washer, and lock
washer supplied in the mounting point. Make sure that
the rubber washer is between the contour strap and the
enclosure. See
Figure 4b.
Leave the other end (the long flat
end) of the contour strap temporarily unattached. Eventually
this will be attached to the mounting point below where
the yoke crossbar is positioned when the loudspeaker is
mounted and aimed properly.