ENTASYS 200 Installation/Operation Manual — Page 15
Installation
4. Tighten top screws. Install and tighten (2) additional 3.5 x16mm Phillips truss head deep thread
screws through bottom slots of bracket into pilot holes in cabinet. Note: Pilot holes are factory
-suggested mounting positions but the bracket may be mounted at any position along the
length of the column as needed to suit a particular installation.
5. Lastly, adjust the final vertical focus angle for optimal coverage. As mentioned on the previous
page, we recommend approximating the vertical angle
before
the loudspeaker is installed in
the bracket, as it becomes harder to adjust the angle
after
the loudspeaker is installed. After
final angle adjustments are made, be sure to tighten all hardware on mounting bracket to
ensure aiming position is secure.
Installing the ENT212 / ENT220 Pan-Tilt Bracket
1. First, remove the Pan-Tilt Bracket from the loudspeaker (note that it comes attached and loosely
fastened together).
2. Next, attach the Pan-Tilt Bracket to the wall surface. Note: Wall mount fasteners are not included
as mounting requirements may vary significantly from one type of wall surface to another.
At this
time, it is advisable to set the downward tilt angle as close as possible to the anticipated
final alignment.
To facilitate installation, you can rotate the bracket one way for easier access to the mounting
holes, then rotate the bracket in opposite direction to install remaining fasteners on the opposing
side (see the diagram below).
1. Referring to the tilt angle reference label,
set estimated tilt angle of loudspeaker and
tighten (3) each, M5 hex head screws and
nuts (item 1)
2. Adjust pan angle of loudspeaker and tighten
(2) each M6 pan pivot nuts (item 2). Further
tighten (2) each M4 hex head socket screws
(item 3)