ENTASYS 200 Installation/Operation Manual — Page 14
Installation
Installing the ENT203 / ENT206 Pan-Tilt Bracket
1.
First, remove the bracket from the loudspeaker. Note that the Pan-Tilt Bracket is shipped
attached to the loudspeaker and loosely assembled (you do not have to assemble it
yourself).
2. Attach bracket to wall. Note: wall mount fasteners are not included as mounting
requirements may vary significantly from one type of wall surface to another.
At this time,
it is advisable to set the downward tilt angle as close as possible to the anticipated
final alignment.
To facilitate mounting , you can rotate the bracket one way for easier access to the
mounting holes, then rotate the bracket in opposite direction to install remaining fasteners
on the opposing side (see diagram below).
3. Install (2) 3.5 x 16mm Phillips truss-head deep thread screws, one on each side, into pilot
hole in slots of enclosure. Note: These will be the screws at the top of the bracket. Choose
holes closest to the top for cabinet stability, thereby allowing the cabinet to tilt without
hitting the wall. Slide cabinet into top of bracket until screws rest in bracket slots (see
illustration below).
NOTE: The following suggested mounting points are
guided by the factory marked pilot holes, and are
measured to allow un-stressed cable installation
while the provided weather cover is installed.
Recommended Installation Practice:
We recommend installing the Pan/Tilt brackets as
high on the cabinet as possible while still allowing
you to achieve the desired install angle. This is to
prevent needless top-heavy installation of the
cabinets when possible.