Communication Machinery Corporation (CMC)
2-2
080104
Back Panel
Connectors
10/100 Ethernet Connector: This connector provides 10/100 Mbps
connectivity to a wired Ethernet LAN. It is used to connect a command PC
to the EmulationEngine.
Serial Port: This connector can also be used to connect a command PC to
the EmulationEngine. The configuration of the serial port is: 9600 bps, 8
data bits, no parity, 1 stop bit, and no flow control
AC Power Connector: This connector is used to connect the
EmulationEngine to the provided power supply.
Antennas
There are two antennas on the back of the device. The system chooses
the best antenna for transmit and receive. The antennas can be swiveled
180 degrees and angled up or down to optimize signal gain.
Reset Button
A recessed reset button is located between the Ethernet Connector and
Power Supply Connector on the back of the unit. It can be used to perform
a hard reset of the EmulationEngine. To perform a hard reset, use a paper
clip to press the reset button.
