www.commscope.com
860543388
Instruction Sheet
Page 7 of 19
6. Insert the panel bus jumper 10-pin connector into the nearest cable bus port on the panel bus as shown
in Detail
A
.
7. Install spare port built into jumper cordage into panel bus frame by turning it at an angle, inserting into
frame, and turning it back perpendicular to frame.
Note:
The connector is keyed. The polarized tab on the jumper connector fits into the nearest port in the
panel bus.
IMPORTANT
: Make sure that the jumper connector is fully seated in the connector on the panel bus.
8. Feed the loose end of panel bus jumper into the back of the shelf through small opening at end of panel
back, as shown in Detail
B
. Carefully route the jumper under any modules or fiber, leaving it loose to be
connected later.
Corrugated
tubing
Black
ribbon cable
iPatch
MPO upgrade kit
iPatch
MPO
upgrade kit
Panel
bus
jumper
Cable retainer
10-pin
connector
Detail A rotated 90°
Spare bus port
(start a new chain
with every 6th panel)
Panel bus
port (max.
of 5 panels
per bus port)
Panel bus
assembly
Black
ribbon cable
Backplane kit
with hole facing
front of shelf
Feed panel
bus jumper
Panel bus
jumper
connector
Flat
retainer clip
Detail B
