TC-96302-IP
Page 5
© 2021
CommScope
. All Rights Reserved.
1.6 Precautions
When installing or operating the panel, observe the following precautions:
• Fiber optic trunk cable and jumper performance is sensitive to bending, pulling, and crushing.
Minimum bend radius must be maintained during installation per the manufacturer’s
specification. Appropriate pulling grips must be used during installation, and pulling forces
shall not exceed manufacturer’s recommendations.
• All wiring that connects to this equipment must meet applicable local and national building
codes and network wiring standards for communication cable.
•
IMPORTANT
: Dust covers are installed in the ports to protect the fibers connected to the back
of the ports. Do not remove a dust cover from a port until you connect a patch cord to that port.
If you remove a patch cord later, replace the dust cover in the port.
•
Prior
to installation, clean the trunk cable and jumper connectors per the manufacturer’s
recommendations.
• Isopropyl alcohol is flammable, and can cause eye irritation on contact. If eye contact occurs,
flush with water for at least 15 minutes. In case of ingestion, consult a physician. Use only in
well ventilated areas.
• Care should be taken not to compromise the stability of the rack by installation of this
equipment.
1.7 Related Publications
The following publication is available by contacting the CommScope Support Center at
https://www.commscope.com/SupportCenter
Title
Number
EPX Panel Quick Start
TC-96301-IP
