TC-96307-IP
Page 29
© 2022
CommScope
. All Rights Reserved.
b. After securing the cable tie to cable, use a side cutter or bend cable tie to remove excess
cable tie.:
Figure 30. Cable Management Clip Detailed View
5. Refer to
for an example of how the cable management clip should look when
installed (in the case on a single cable).
Figure 31. Cable Assembled on Cable Management Clip
6.5.2
Installing a Cable and Clip Assembly onto the Cable Management Bracket
To install a cable and clip assembly in the cable management bracket. insert the lead bottom
feature of the clip into the selected slot, and slide it in to the final position shown in
and
Start at forward most position and install additional cables working toward back of panel.
Note:
Ensure that the cable breakout is not retained by the tie wrap, referring to the guidelines
provided in
and in the installation drawing provided with the cable assembly.
27610-A
ATTACH CABLE OR CABLES TO
SNAP-IN MOUNTING CLIP WITH
INCLUDED CABLE TIES OR ANY
STYLE OF CABLE TIE YOU PREFER
AFTER SECURING CABLE TIE TO CABLE
YOU CAN USE A SIDE CUTTER OR BEND
CABLE TIE AT BASE TO REMOVE
EXCESS CABLE TIE TO REMOVE
EXCESS CABLE TIE
ALIGN THE BACK OF THE SNAP-IN
CABLE MOUNTING CLIP TO THE BACK
OF THE HEAT SHRINK ON CABLE JACKET.
THIS WILL GIVE YOU THE CORRECT
22” BREAKOUT LENGTH
FOR THE CHASSIS
FOR REFERENCE ONLY:
SLOT IN MOUNTING CLIP CAN ALSO
BE USED TO ATTACH CABLES WITH
PANDUIT HLT OR COMMSCOPE
HOOK AND LOOP CABLE
TIES (1375254-2) (NOT INCLUDED)
EXTRA CABLE TIE
MOUNTING SLOT
FOR ADDING
CABLES
HEAT-SHRINK END
HEAT-SHRINK
27611-A
HEAT-SHRINK (AT CABLE
BREAKOUT IF ANY)
TIE WRAPS (2x)
CABLE MANAGEMENT CLIP
