Example MP11x FXO Setup Guide v1.6
Last Updated: 6/11/18
P a g e
|
6
would match none.
e.
Source IP Address
matches the IP Address of the source of the call. This is obtained
from the CONTACT header in the SIP INVITE. An * would match any number (0-255)
and x would match a single digit. For example, 10.10.x.* would match any Source IP from
10.10.0.000 to 10.10.9.255.
f.
Hunt Group ID
indicates the Hunt Group from Step 6 (Hunt Group Settings).
g.
IP Profile ID
indicates the IP Profile to use (created later).
h. Example FXO configuration:
Dest. Phone Prefix = *
Source Phone Prefix = *
Source IP Address = *
Hunt Group = 1
IP Profile ID = 1
8. FXO Settings (Dial Mode)
a.
Configuration
>
VoIP
>
GW and IP to IP
>
Analog Gateway
>
FXO Settings
b.
Dialing Mode
setting determines how calls are dialed on the phone line.
O
ne-stage
dialing seizes one of the available lines and dials based on Step 6
Channel Select Mode. It dials the destination phone number received in the SIP
INVITE
. Consider the “
Waiting for Dial Tone
” value to specify whether the
dialing will start immediately or only after detection of the dial tone.
Two-stages
dialing seizes one of the available lines without performing any
dialing and connects the remote SIP device. All further signaling (Dialing and Call
Progress Tones) is/are performed directly from the remote SIP device. This gives
flexibility to the remote SIP device to choose what dialing happens next. For
example, a local PBX extension or 9 (for an outside line) is dialed.
c. Example FXO configuration:
Dialing Mode = One Stage
