Step 6:
Cable Tray 973, 970 brackets to Actuators. Place the rear of the actuator on a flat
surface. Orientate part 973 so the front is upper most. And the actuators are sitting in either
end. Slid parts 970 in from each end between 973 and the actuator. Using 8x 6mm Cap
Screws secure these parts in place
Step 7:
Using a
minimum of two
people raise the
actuators so there
base is sitting on a
flat surface. Tilt the
Tilt Brackets so they
are at 90
° as shown.
Then flip this
apparatus over. And
place the base on
top. Ensuring the rear
of the top frame lines
up with the rear of
the base. Using 8x
6mm Cap Screws
secure the base to
the frame.
