SYSTEM CONTENTS
1
TROUBLE SHOOTING
10
Each system contains the following components:
1- Brain Module
1- 3 Button Transmitter ( L.C.D SCREEN )
1- External Receiver W/ harness
1- 6 Ton Siren
1- Impact Sensor Dual Zone W/ harness
1- 10 pin wiring harness
6- (12 G.) Wires W/2 Fuse Holders
1- 3 pin door lock harness
1- 3 pin wiring harness
1- 2 pin wiring harness
1- Red Status L.E.D.
1- Push Button Switch
Note:
Read this instruction manual thoroughly.
Important:
This unit is designed for a professional installation only.
Any installation performed by an unqualified installer, Will void the warranty.
Probable Cause
Problem
Unit will not operate
All power inputs are not
connected to 12V+
Remote start in Service
mode LED is ON solid
Turn ignition key to ON
position, press and hold
service switch for 5 sec.
LED will go out
Crank time must be
increased.
Engine Cranks but
not long enough to
allow vehicle to start.
Ignition #1 (Yellow Wire)
is on wrong connector-
Ignition/Accessory #2
RS will not go into
Code Learning or
Programming Mode.
Connect the main ignition
Input/Output to the Ignition
#1 connector on the Board.
To Exit mode: 1. Press
brake pedal, then Press
Valet Switch, Press and
hold Button #2 for 5 sec.
(Lights will flash 10 x's)
Check Brake switch input
(Yellow Wire) for (+) or
Hood input (Blue Wire)
for (-) shorted to ground
Connect red wire one
accessory plug (red plug)
to Factory Alarm disarm
wire.
Vehicle has a factory
alarm system.
Car Horn Honks
and Vehicle will not
start.
RS in Automatic Cold
Start Activation Mode.
Vehicle starts without
pressing Remote
Transmitter.
Extend the gray wire from
the main harness to a
sparkplug wire (wrap-
around), put dip switch #4
in the on position.
Voltage sense is not
working. Use the spark
or Tech sense.
Vehicle cranks and
begins to run, then
shuts off.
Vehicle has theft
deterrent system that
prevents starting w/o key
in ignition.
See manual on Passlock
PATS theft deterrent
systems.
Vehicle cranks and
begins to run, then
shuts off.
Keyless Entry
operates but engine
will not start
Vehicle will not
remote start
Safety inputs are
triggered
Main inputs heavy gauge
red wires and red fused
wire on main harness
must be connected to 12+
Place dip switch #3 to the
ON position
Suggestions
Button #1
Door
Lock / Unlock
Arm & Disarm
Button #3
Trunk Open
Button #2
Remote
Engine Start
Antenna
LCD Display
R
R
R
S
S
D
Press Button 2 & 3
To Check Car Alarm Status
S
