Do it your way
2
ASSEMBLY
1.
Make sure valve is OFF by turning knob in direction of
arrow (clockwise) until hand tight only. DO NOT FORCE.
2.
Turn fuel cartridge clockwise into valve body until hand
tight. DO NOT FORCE.
LIGHTING AND OPERATION
1.
To light with a match, hold as
shown and open valve slowly.
¼ turn is normally enough.
2.
To light with hand sparker,
open valve slowly before
sparking, ¼ turn is
normally enough.
3.
Hold hand sparker at a 45° angle
to the torch opening. NOTE: It is
very difficult to light with valve
fully open.
4.
For hottest, most efficient flame,
adjust inner blue flame of pencil
burner to 4-5 cm in length.
5.
If ignition does not occur
immediately upon opening
the torch valve, close the valve
and wait 5 minutes before
attempting to ignite again.
Failure to follow this instruction
could result in a build up of
flammable gas which if ignited
could result in a fireball that
could cause injuries and
property damage. Do not open
the valve and allow gas to flow
through the torch without
attempting to ignite the torch.
ADDITIONAL WARNINGS
Make sure torch is cool before
tightening or removing burner
head, or before installing or
removing accessories.
Check all joints and couplings
periodically to insure against
loose connections. With
valve open, without lighting,
test all connections with leak
detection spray or soapy water.
If bubbles appear, gas is leaking
and torch must be repaired.
Never Use a flame to check
for leaks. Make this test in a
well-ventilated and spark-free
area, and where there are no
open flames.
In cold weather the size of
the flame will be smaller.
To produce a larger flame,
pre-warm the cartridge to room
temperature prior to use.
NOZZLE
TUBE
SPINDLE
CONTROL
KNOB
BODY
INSERTED SHAFT
ADDITIONAL NOTE: As a safety feature, the burner may snap
if the torch is dropped, in which case the burner must be
replaced.
STORAGE
ALWAYS REMOVE CARTRIDGE FROM TORCH WHEN NOT IN USE
1.
Make sure valve control knob is closed by turning fully
clockwise until it stops. Do not force.
2.
When torch is cool, disconnect cartridge and store torch
and cartridge separately and out of reach of children.
Observe cautions on cartridge label.
3.
Do not expose cartridges to temperatures in excess of 49ºC.
4.
Store cartridges in well ventilated areas.
SAVE THESE INSTRUCTIONS
DO NOT DISCARD
THESE WARNINGS AND
INSTRUCTIONS
DISTRIBUTED BY
TRADEPEM INDUSTRIAL PTY LTD
WWW.COMMANDTOOLS.COM.AU
STEP 1
STEP 2
